Impeller part/source 2015 PCM 350 T22

NWilly · **Joined:** Mon Feb 02, 2015 6:32 pm **Posts:** 15

Trying to figure out what I need. Couldn't find a thread on it.

Any tips/tricks for a newbie doing this work?

get_sum · **Posted:** Sun Aug 21, 2016 8:46 am

Impeller puller works easiest but I've done it without. Here's the part you'll need.

http://www.bakesonline.com/detail.aspx?ID=276

Sent from my iPhone using Tapatalk

NWilly · **Joined:** Mon Feb 02, 2015 6:32 pm **Posts:** 15

I had looked at Bakes prior to posting.

I don't have an Indmar motor, is this still the right part?

get_sum · **Posted:** Sun Aug 21, 2016 8:49 am

Here's the puller I have. It works well as long as you have it in all the way.

http://www.bakesonline.com/detail.aspx?ID=1244

Sent from my iPhone using Tapatalk

AJWest · **Posted:** Sun Aug 21, 2016 10:52 am

Use a zip-tie around the new impeller when installing.

simo47 · **Posted:** Sun Aug 21, 2016 12:59 pm

http://www.crusaderengines.com/wp-conte ... 032-14.pdf pg.41

part # RP061018

http://www.nautiqueparts.com/impellerin ... npump.aspx

elc · **Posted:** Sun Aug 21, 2016 1:04 pm

yes same part as the indmar impeller. I just changed my pcm impeller. I usually use two screw drivers and pop the impeller out. if that doesn't work i start it with the screw drivers and pull it out with needle nose pliers. I'm sure the puller is easier but usually I can change the impeller in 15 min with the method described above.

shawndoggy · **Joined:** Sun Jun 16, 2013 11:19 pm **Posts:** 263

is the crusader setup different than the PCM EX343? I never used a puller with that setup on my MB...

shawndoggy · **Joined:** Sun Jun 16, 2013 11:19 pm **Posts:** 263

huh, yep it is different than the EX343.

Axis Wakeboard Boat Forum

Impeller part/source 2015 PCM 350 T22

Who is online